Variable Frequency Drive (VFD) Installation Contractor in Kenya
There are two ways to control flow: throttle it, or slow the pump. For decades, industry throttled — running motors at full speed and fighting the output with valves, dampers, and gears, wasting enormous energy in the process. The variable frequency drive changed that equation. A VFD varies motor speed to match demand, cutting energy consumption dramatically in the right applications. Pro-Logic Technologies is a VFD installation contractor in Kenya, helping businesses select, install, commission, and maintain drives correctly.
Where VFDs Pay Off
The physics is simple: for centrifugal fans and pumps, power falls roughly with the cube of speed. Slow a pump to 80 percent and you may draw only about half the power. VFDs shine wherever flow varies — water pumping and pressure boosting, HVAC fans, irrigation, compressors, mixers, conveyors, and extruders. Beyond energy, VFDs deliver soft starting that removes mechanical shock from belts, bearings, and couplings; precise speed control that improves product quality; and built-in protection against overload and phase problems. In Kenya, they also mitigate the grid's voltage dips and phase imbalances that shorten motor life.
Our VFD Services
Application assessment. Not every motor should have a drive. We assess your load type, duty cycle, and process needs, and advise honestly where a VFD will save money and where simpler solutions — soft starters, or nothing — are the better engineering call.
Drive selection. We size drives correctly for the motor, load type, and duty, accounting for overload requirements and ambient conditions. Undersized or mismatched drives fail early; we select for a long service life.
Professional installation. VFDs punish sloppy installation. We install drives with correct input and output cabling, proper screening and earthing to contain the electrical noise drives generate, adequate cooling and enclosure ventilation, and correct clearances. Input protection, reactors, and filters are fitted where the application and installation environment demand them.
Motor and cabling checks. We verify that the target motor is VFD-compatible, checking insulation grade for the voltage stresses drives impose, and reviewing cable lengths and type. Where motors are unsuitable, we advise before, not after, failure.
Commissioning and tuning. A VFD out of the box is a VFD at its worst. We parameterize each drive to its application — ramp times, speed limits, PID settings for pressure and flow control, braking arrangements, and protective limits — then test under real load and document the settings.
Integration. We integrate drives with control systems: remote start/stop, analog speed control from sensors and controllers, communication to PLCs and SCADA where required, and interlocks with your process logic.
Maintenance and support. Drives need clean cooling and healthy electronics. Our maintenance programmes inspect drives, clean filters and heatsinks, verify parameter integrity, and address faults early — supported by our ability to diagnose drive, motor, and control-circuit problems as one system.
Sectors We Serve
Water utilities and borehole operators, irrigation schemes, HVAC contractors and building managers, manufacturers, food and beverage processors, cold storage, mills, hotels, and workshops. Wherever motors run flows that vary, we deliver drives that pay for themselves.
Why Choose Pro-Logic Technologies
VFD success is decided in the details — screening, earthing, parameters, and motor compatibility — and details are our business. As electrical contractors, we handle the complete scope from supply assessment to motor, so nothing falls between specialists. Our commissioning documentation keeps your drives maintainable by anyone, including us, for years.
If your pumps and fans run flat out against throttles and valves, you are paying for energy you never needed. Contact Pro-Logic Technologies for a professional VFD assessment and start saving with every turn of the motor.